2010 Chevy Camaro Oil Pressure Gauge Not Working

The number one reason that your Camaro would have low oil pressure.

2010 chevy camaro oil pressure gauge not working. I did not the build the engine in my car and do not have any way to contact who did. Below well review the most common causes. That is OK because the information on the Camaro fuel gauge can be used to diagnose and fix all other GM fuel gauges.

2010 Camaro SSRS IOM 475rwhp 415ftlbs Cam-232245 612 612 113LSA. As for the oil pressure gauge no 2nd gen Camaro had an oil pressure gauge. Disconnect the wire from the sending unit and use an Open Ended Wrench to remove the sender.

Your original gauge faces can now be restored to factory fresh appearance by using this gauge pkg from gauge marks. Includes 4-pack gauge cluster plug-and-play wiring harness center insert replacement piece and. Also I think I noticed the fan was kicking on also not too sure what it was.

At 55k miles 3 years ago I had a collapsed valvespring car was towed to dealer and top end parts replaced drivers side headgasket replaced etc. Oil pressure gauge the needle was a bit past 70 yet the computer said the oil pressure was 67 to 68 PSI. Also Ive had 5 of these 3rd gen Camaros so you need to invest in a good book Haynes Manual.

And also my oil life percentage right now is at 32. Cold start up this morning. After 1965 GM changed the gauge from 0-30 ohm to 0-90 ohm to improve accuracy.

If you know some one with a good scan tool you could do a gauge sweep test with it to se if the gauge works thru its proper range. We advise not running the engine until the issue can be properly diagnosed. 1969 Chevrolet Camaro Oil Pressure Guage Line Leaking.